Panasonic KX- TG2583B manual ProblemRemedy

ProblemRemedy

The unit does not display the caller’s name and/or phone number

*YOU need to subscribe to a Caller ID service from a telephone company *Other telephone equipment may be

interfering with your phone Disconnect it and try again

*Other electrical appliances connected to the same outlet may be interfering with the Caller ID information

*Telephone line noise may be affecting the Caller ID information

The handset or base unit display goes to the standby mode while viewing the Caller List

*Do not pause for over 60 seconds while searching

When a second call is received during a conversation, the unit does not display the new caller’s name and/or phone number

*The line mode selection is incorrect See page 14

You cannot page the		*The handset is too far from the base unit
handset or the base unit		*The handset or the base unit is engaged
		in an outside call, viewing the Caller
		List/directory list or listening to
		messages Try again later If you are
		using the base unit, wait until “Handset
		in use" disappears
You cannot redial by		*If the last number dialed was more than
pressing		32 digits long, the number will not be
	(REDIAUPAUSE]
		redialed correctly
		*Access numbers entered after pressing
		(TONE) will not be included when
		redialing
		*The button has a double function as
		either redial or pause It will redial the
		last number dialed if pressed at the
		outset of a call (p 26, 29) If another
		number has been dialed first, it will
		operate as a pause button (p 54)

75