Base unit settings, Base unit ringer volume

Press {MENU}.

Programmable Settings

Base unit settings

Base unit ringer volume

4 levels (high/medium/low/off) are available. The default setting is HIGH.

Important:

LMake sure the base unit is not being used.

Press {<} or {>} repeatedly to select the desired volume.

LTo stop ringing, press {STOP}.

To turn the ringer off, press and hold {<} until the unit beeps 2 times.

L“O” will be displayed.

Note:

LWhen the ringer volume is set to off, the base unit will not ring for outside calls and it will ring at the low level for intercom calls.

LWhen the ringer volume is set to off, the base unit will not announce caller names (page 26).

Base unit ringer tone

You can change the base unit ringer tone heard when an outside call is received. There are 3 tones and 4 melodies. The default setting is “Tone 1”.

This feature must be set by using the handset.

2 Scroll to “Initial setting” by pressing {V} or {^}, then press {>}.

3 Scroll to “Set base unit” by pressing {V} or {^}, then press {>}.

4 Scroll to “Ringer tone” by pressing {V} or {^}, then press {>}.

5 Press {V} or {^} repeatedly to select the desired setting.

LYou can also select the ringer tone by pressing {1} to {7}.

LIf the ringer volume has been turned off, the base unit will not ring.

6 Press {Save}, then press {OFF}.

Note:

LIf you subscribe to a distinctive ring service (such as IDENTA-RING), select a tone (Tone 1 to 3). If you select a melody, you will not be able to distinguish lines by their ringers.

LIf you select one of the melody ringer patterns, the ringer will continue to sound for several seconds if:

–the caller hangs up before you answer the call.

–another person answers the call using another phone connected on the same line.

Base unit interrupt tone

This tone lets you know when you receive a call while you are on an intercom call (page 31).

“2” (default): The tone will sound 2 times.

“On”: The tone will sound for as long as the line rings.

“Off”: Turns this feature off.