Programming
the handset momentarily. This is normal
and the handset can be used once 
is displayed.
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the base unit.
Important:
RThe additional handset model recommended for use with this unit is noted on page 4. If another handset model is used, certain operations (handset settings, base unit settings, etc.) may not be available.
Registering a handset to the base unit
The supplied handset and base unit are 
is displayed even when the handset is near the base unit),
1Handset:
#130
2Base unit:
Press and hold M
N for about 5 seconds. (No registration tone)
R If all registered handsets start ringing, press M
N again to stop, then repeat this step.
R The next step must be completed within 90 seconds.
3Handset:
a Wait until “Base PIN” is displayed. a Enter the base unit PIN
(default: “0000”). a 
R If you forget your PIN, contact an authorised service centre.
R When the handset has been registered
successfully, 
is displayed.
Note:
R While registering, “Base in registering” is displayed on all registered handsets.
RWhen you purchase an additional handset, refer to the additional handset’s installation manual for registration.
Deregistering a handset
A handset can cancel its own registration to the base unit, or other handsets registered to the same base unit. This allows the handset to end its wireless connection with the system.
1
#131
R All handsets registered to the base unit are displayed.
2MbN: Select the handset you want to cancel. a 
3MbN: “Yes” a 
R A confirmation tone sounds.
R The handset does not beep when cancelling its own registration.
4M
N
Increasing the range of the base unit
You can increase the signal range of the base unit by using a DECT repeater. Please use only the Panasonic DECT repeater noted on page 3. Contact your Panasonic dealer for details.
Important:
RBefore registering the repeater to this base unit, you must turn the repeater mode on.
RDo not use more than one repeater at a time.
Setting the repeater mode
1
#138
2MbN: Select the desired setting. a 
a M
N
29
TG6711FX(en)_0130_ver002.pdf 29
2012/01/30 18:56:54
