Programming
5Handset:
Wait until “Enter Base PIN” is displayed. i Enter the base unit PIN (default: “0000”). i M L If you forget your PIN, contact
your nearest Panasonic service centre.
L When the handset has been registered successfully, w stops flashing.
Note:
L When you purchase an additional handset, refer to the additional handset’s installation manual for registration.
Deregistering a handset
A handset can cancel its own registration (or the registration of another handset) that is stored in the base unit. This allows the handset to end its wireless connection with the system.
1K(middle soft key)
2{V}/{^}: “Base Unit Setup” i
M
3{3}{3}{5}
4{V}/{^}: “Deregistration” i
M
L The numbers of all handsets registered to the base unit are displayed.
5Select the handset(s) you want to cancel by pressing the desired handset number. i M
L The selected handset number(s) flashes.
L To cancel a selected handset number, press the number again. The number stops flashing.
6{V}/{^}: “Yes” i M
L A confirmation tone sounds as each handset number disappears.
LThe handset does not beep when cancelling its own registration.
7{ih}
Increasing the range of the base unit
You can increase the signal range of the base unit by using a DECT repeater. Please use only the Panasonic DECT repeater noted on page 4. Contact your Panasonic dealer for details.
Important:
L Before registering the repeater to this base unit, you must turn the repeater mode on.
L Do not use more than one repeater at a time.
Setting the repeater mode
1K(middle soft key)
2{V}/{^}: “Base Unit Setup” i
M
3{V}/{^}: “Repeater Mode” i
M
4{V}/{^}: Select the desired setting. i Mi {ih}
Note:
L After turning the repeater mode on or off, w flashes on the handset momentarily. This is normal and the handset can be used once w stops flashing.
28