Panasonic KX-TG8012BX, KX-TG8021BX, KX-TG8011BX operating instructions Error messages

TG8011_8021BX(e).book Page 44 Monday, September 29, 2008 1:07 PM

Useful Information

Error messages

If the unit detects a problem, one of the following messages is shown on the display.

Display message	Cause/solution
Answer Sys. Full*1	L Erase unnecessary messages (page 35).
Check Tel Line	L The supplied telephone line cord has not been
	connected yet or not connected properly. Check the
	connections (page 12).
Error*1	L Recording was too short. Try again.
Failed	L Phonebook copy failed (page 22). Confirm the other
	handset (the receiver) is in standby mode and try
	again.
Incomplete	L The receiver’s phonebook memory is full. Erase the
	unnecessary phonebook entries from the other
	handset (the receiver) and try again.
Memory Full	L The phonebook memory is full. Erase unnecessary
	entries (page 21).
	L Message memory is full. Erase unnecessary
	messages (page 35).*1
	L The maximum number of base units (4) is already
	registered to the handset. Cancel unused base unit
	registrations from the handset (page 30).
No link to base.	L The handset has lost communication with the base
Reconnect AC	unit. Move closer to the base unit and try again.
adaptor.	L Unplug the base unit’s AC adaptor to reset the unit.
	Reconnect the adaptor and try again.
	L The handset’s registration may have been cancelled.
	Re-register the handset (page 29).
Use rechargeable	L A wrong type of batteries such as Alkaline or
battery.	Manganese was inserted. Use only the rechargeable
	Ni-MH batteries noted on page 5, 13.
You must first	L You must subscribe to a Caller ID service. Once you
subscribe to	receive caller information after subscribing to a Caller
Caller ID.	ID service, this message will not be displayed.
*1 KX-TG8021

44