Operating additional units
Additional handsets
Up to 5 handsets can be registered to a single base unit.
Important:
LThe additional handset model recommended for use with this unit is noted on page 4. If other model handset is used, certain operations (handset settings, base unit settings, etc.) may not be available.
LAdditional handsets will give you the freedom to, for example, have an intercom call with another handset while a third handset is on an outside call.
Additional base units
Handsets can be registered to up to 4 base units, allowing you to add additional base units and extend the area in which your handset(s) can be used. You need to select the desired base unit to use the handset with (page 19).
Registering a handset to a base unit
The supplied handset and base unit are pre- registered. If for some reason the handset is not registered to the base unit (for example, w flashes even when the handset is near the base unit), register the handset.
1Press and hold {x} on the base unit for about 5 seconds until a beep is heard.
L If all registered handsets start ringing, press {x} to stop, then repeat this step.
L After a beep is heard, the rest of this procedure must be completed within 1 minute.
2{MENU} (right soft key) iri{OK}
3{^}/{V}: “Registration” i{OK}
4{^}/{V}: “Register Handset” i{OK}
5{^}/{V}: Select a base unit number. i{OK} L This number is used by the handset as a
reference only.
L The registered base unit is indicated by “@”.
6“Enter PIN” is displayed. Enter the base unit PIN (default: “0000”). i{OK}
L If you forget your PIN, consult your nearest Panasonic service centre.
L When the handset has been registered successfully, w will stop flashing. If the key tone is turned on (page 15), a confirmation tone will be heard.
Selecting a base unit
When a specific base unit is selected, the handset will make and receive calls using that base unit only. If the handset is out of range of that base unit, no calls can be made.
1{MENU} (right soft key) iri{OK}
2{^}/{V}: “Select Base” i{OK}
3{^}/{V}: Select the desired base unit. i
{OK}
L The selected base unit is indicated by “t” located on the left of the item on the display.
L The handset starts searching for the base unit.
Deregistering a handset
A handset can cancel its own registration (or the registration of another handset) that is stored in the base unit. This will allow the base unit to “forget” the handset.
1{MENU} (right soft key) iri{OK}
2{^}/{V}: “Registration” i{OK}
3{^}/{V}: “Deregistration” i{OK}
4Enter the base unit PIN (default: “0000”). i
{OK}
L If you forget your PIN, consult your nearest Panasonic service centre.
L The numbers of all handsets registered to the base unit are displayed.
L The handset you are using is indicated by
“t” located on the left of the item on the display.
5{^}/{V}: Select the handset(s) you want to cancel. i{OK}
6{YES} i{i}
Note:
L“Register!” is shown on the handset display when you cancel registration.
19
