Preparation
Battery level
Battery icon | Battery level |
@ | High |
? | Medium |
/Low
L When flashing: Needs to be charged.
Panasonic
Operation | Operating time |
In continuous use | 10 hours max. |
In continuous standby | 100 hours max. |
mode |
|
Note:
LIt is normal for batteries not to reach full capacity at the initial charge. Maximum battery performance is reached after a few complete cycles of charge/discharge (use).
LTo maximize battery life, it is recommended that the handset batteries be fully discharged (used) until / flashes once every few months.
L Actual battery performance depends on a combination of how often the handset is in use and how often it is not in use (standby).
LThe battery level may not be displayed correctly after you replace the batteries. In this case, place the handset on the base unit and let it charge for at least 8 hours.
Screen saver mode
If the handset is not on the base unit
The backlight will turn off completely after 1 minute of inactivity, even when on a call.
To use the handset when it is in screen saver mode, activate the handset display again by:
–pressing {^} or {V} when on a call
–pressing {i} for all other times
While charging
The backlight will be dimmed after 1 minute of inactivity. The backlight can be turned off completely depending on the setting (page 15). To use the handset when it is in screen saver mode, lift the handset to activate the handset display again.
Setting up the unit before use
Display language
1{i} i{MENU}
2Select rby pressing {^}, {V}, {<}, or {>}.
i{OK}
3Press {^} or {V} to select “Display Setup”.
i{OK}
4Press {^} or {V} to select “Select Language”. i{OK}
5Press {^} or {V} to select the desired language.i{OK} i{i}
Note:
L If you select a language you cannot read: {i}
i{MENU} (right soft key) i{>} 2 times i {OK} (right soft key) i{V} 2 times i{OK} (right soft key) i{V} 2 times i{OK} (right soft key) i{^}/{V}: Select the desired language. i{OK} (right soft key) i{i}
10
