Y

Programming using the Handset

26
Programmable settings
You can customize the unit by programming the following features.
To access the features, there are 2 methods:
– scrolling through the display menus (page 26)
– using the direct commands (page 27)
Some of the features can be programmed through the Web user interface (page 40).
LDirect command is the main method used in this User Guide.

Programming by scrolling through the display menus

1{MENU} (center of joystick)
2Select the desired main menu by pushing the joystick in any direction. i {SELECT}
3Push the joystick down or up to select the desired item in sub-menu 1. i {SELECT}
LIn some cases, you may need to select from sub-menu 2. i {SELECT}
4Push the joystick down or up to select the desired setting. i {SAVE}
LThis step may vary depending on the feature being programmed.
LTo exit the operation, press {OFF}.
Note:
LSee page 27 for the default settings.
LIn the following table, ( ) indicates lines you need to select for the settings.
Main menu Sub-menu 1 Sub-menu 2 Page
Line status
m
––10
IP service Network setting DHCP*1 –
IP settings*1 –
Embedded web 40
Call features Call forward
(Line 1: 8 max.)
–Unconditional*1
–Busy*1
–No answer*1
29
Do not disturb*1
(Line 1: 8 max.)
30
Block anonymous*1
(Line 1: 8 max.)
30
Block Caller ID*1
(Line 1: 8 max.)
31
New Voice Mail
#
––44
Intercom
x
– – 45, 46