Panasonic MCUL815 operating instructions Replacing Belt

Replacing Belt

Side Latch

Loquet latéral

Pestillo laterale

Rear Latch

Loquet arrière

Pestillo trasero

Nozzle Cover	Side Latch
Couvercle de la	Loquet latéral
tête d'aspiration	Pestillo laterale
Cubierta de la boquilla

	Belt
	Courroie
Agitator	Correa
Agitateur
Agitador

Motor Shaft

Arbre du moteur

Eje del motor

		Belt Guide
		Glissière de
		la courroie
	End Cap	Guía para la
Belt Groove		correa
	Bouchon
Rainure de
	Tapa del
la courroie
	extremo
Polea para
correa

➢Replace belt whenever a burning rubber smell caused by excessive slippage occurs.

➢Turn off and unplug the vacuum cleaner.

➢Push in rear nozzle latch.

➢Press side latches towards back of nozzle and rotate cover from nozzle.

➢Remove agitator by carefully lifting out.

➢Remove worn or broken belt.

➢Clean agitator and the end caps.

CAUTION

Motor shaft may be hot.

➢Loop new belt (part number MC-V380B) around motor shaft and agitator belt groove. Make sure belt is routed in the belt guide as shown. See illustration for correct belt routing.

➢Reinstall agitator back into nozzle by placing end caps into grooves.

➢After reinstalling the agitator, turn it by hand to make sure that belt is not twisted or pinched and that all rotating parts turn freely.

➢Reinstall nozzle cover by aligning front edge of the cover with the nozzle and rotating. Ensure rear latch and side latches are locked into slots by pressing firmly.

- 48 -