3Select a program number on the TV which you wish to use as the video viewing channel. Then tune in the TV to the picture from the screen being auto tuned or the screen selected with the I and J buttons of the VCR.
≥During Auto Tuning, the TV program screen does not appear, and the Auto Tuning screen appears instead.
|
| 2 |
AUTO CHANNEL SET | AUTO TUNING IS | |
PROCEEDING | COMPLETED. | |
END | : MENU | END: MENU |
To Cancel Auto Tuning Mid- Operation
Press MENU during Auto Tuning. Auto Tuning is cancelled.
To Restart Plug in Auto Tuning
1Press < EJECT and remove the video cassette.
2Keep the I and J buttons on the VCR pressed simultaneously for 3 seconds or more during the VCR on.
≥The channel displayed on the VCR display disappears for a moment then changes to 2.
Display Symbol
Disappears 
2
3Disconnect the mains lead and then reconnect it.
4Turn off the VCR and then turn it on. Press VCR/TV to select the VCR mode.
≥Auto Tuning commences.
If Auto Tuning stops halfway by turning the VCR off, playback or a power failure:
1 Disconnect the mains lead and then
reconnect it. |
| |
2 Turn off the VCR and then turn it on. |
| |
| ||
≥Auto Tuning commences. |
| |
To Change the RF Output | Up | |
Setting | ||
Channel | ||
| ||
In some rare cases after tuning the TV to your |
| |
VCR, interference may be visible on the |
| |
picture. To get rid of this interference, you can |
| |
manually adjust the RF output channel a few |
| |
channels up and down from the current setting. |
| |
The procedure is described below. |
|
1Hold down MENU for 5 seconds or more.
≥The VCR display changes as shown below and the VCR picture on the TV displays this pattern.
Panasonic VCR
END: MENU
2Enter the desired channel number (US3 or US4) by the I and J buttons.
3()4
3Press MENU to finish the setting mode.
4Retune your TV to the new RF channel for the VCR.
Note:
≥Even if the RF output channel has been changed, it is not necessary to perform Auto Tuning.
13
