Before using
ªRemoving the battery
While pushing the [PUSH BATT] button, slide the battery (or the DC input lead) to remove it.
PUSH
BATT
≥Hold the battery with your hand so it does not fall.
Charging time and recordable time
The times shown in the table below show the times at a temperature of 25oC and a humidity of 60%. This is just a guide. If the temperature is higher or lower than the specified value, the charging time will become longer.
Supplied | A | 2 h. 25 min. |
battery/ | B | 2 h. 40 min. |
| (2 h. 25 min.) | |
(7.2 V/ | C | 1h. 20 min. |
1150 mAh) |
| (1 h. 15 min.) |
A | 2 h. 45 min. | |
(7.2 V/ | B | 3 h. |
1360 mAh) |
| (2 h. 50 min.) |
| C | 1h. 30 min. |
|
| (1 h. 25 min.) |
A | 3 h. 55 min. | |
(7.2 V/ | B | 4 h. 30 min. |
2040 mAh) |
| (4 h. 15 min.) |
| C | 2 h. 15 min. |
|
| (2 h. 10 min.) |
A | 1 h. 40 min. | |
(7.2 V/ | B | 1 h. 25 min. |
640 mAh) |
| (1 h. 20 min.) |
| C | 45 min. |
|
| (40 min.) |
| A | 1 h. 30 min. |
(7.2 V/ | B | 1h. 30 min. |
680 mAh) |
| (1 h. 25 min.) |
| C | 45 min. |
|
| (45 min.) |
ACharging time
BMaximum continuously recordable time C Intermittent recordable time
(The intermittent recordable time refers to recordable time when the recording and stopping operations are repeated.)
“1h. 10 min.” indicates 1 hour 10 minutes. ≥The battery
10
≥The times shown in the table are rough estimates. The times indicate the recordable times when the viewfinder is used. The times in parentheses indicate the recordable times when the LCD monitor is used.
≥We recommend the Battery Pack
≥The recordable time will become shorter in the following cases:
≥When you use both the viewfinder and the LCD monitor simultaneously while rotating the LCD monitor frontward to record yourself, using the 0 lux night view function, etc.
≥When you use this camera with the LCD monitor lit up by pressing the [POWER LCD] button.
≥The batteries heat up after use or charging. The main unit of the movie camera being used will also heat up. This is normal.
≥Along with the reduction of the battery capacity, the display will change: r# s# t# u# v. If the battery discharges, then u(v) will flash.
Inserting/removing a cassette
1Slide the [OPEN/EJECT] lever and open the cassette cover.
OPEN/
EJECT
≥When the cover is fully opened, the cassette holder will come out.
2After the cassette holder is opened, insert/ remove the cassette.
≥When inserting a cassette, orient it as shown in the figure, and then securely insert it as far as it goes.
≥When removing, pull it straight out.
VQT0N57
