Panasonic NV-GS75EB operating instructions Setting date and time, Adjusting LCD monitor/viewfinder

Before using

VAR.

SEARCHMENU

ENTER

3Press the [MENU] button to exit the menu screen.

VAR.

SEARCHMENU

ENTER

Setting date and time

If the screen shows the incorrect date/time, then adjust it.

≥Set to Tape Recording Mode or Card

Recording Mode.

1Set [BASIC] >> [CLOCK SET] >> [YES].

2Move the joystick left or right in order to select the item to be set. Then move the joystick up or down to set the desired value.

≥The year will change as follows: 2000, 2001, ..., 2089, 2000, ...

≥The 24-hour clock is used.

3Press the joystick to determine the setting.

≥The clock function starts at [00] seconds.

ªAbout date/time

≥The date and time function are driven by a built- in lithium battery.

≥Make sure to check the time before recording because the built-in clock is not very accurate.

ªRecharging the built-in lithium battery

≥If [0] or [--] is indicated when the camera is turned on, then the built-in lithium battery runs down. Connect the AC adaptor to the camera or place the battery on the camera, and the built-in lithium battery will be recharged. Leave the camera as is for approx. 24 hours, and the battery will drive the date and time for approx. 6 months. (Even if the [OFF/ON] switch is set to [OFF], the battery is still being recharged.)

WARNING

THE LITHIUM BATTERY IN THIS EQUIPMENT MUST ONLY BE REPLACED BY QUALIFIED PERSONNEL. WHEN NECESSARY, CONTACT YOUR LOCAL PANASONIC SUPPLIER.

Adjusting LCD monitor/viewfinder

ªAdjusting the brightness and colour

level

1Set [SETUP] >> [LCD SET] or [EVF SET] >> [YES].

2Move the joystick up or down in order to select the item to be adjusted.

[LCD SET]

:Brightness of the LCD monitor

:Colour level of the LCD monitor [EVF SET]

EVF :Brightness of the viewfinder

3Move the joystick left or right to move the bar indication representing the brightness.

4Press the [MENU] button or the joystick to complete the settings.

≥In order to adjust the brightness of the viewfinder, close the LCD monitor, and the

viewfinder will be activated.

≥When the LCD monitor is rotated by 180° towards the lens, the brightness of the LCD monitor cannot be adjusted.

≥These settings will not affect the images actually recorded.

ªIn order to increase the brightness of

the entire LCD monitor

1Press the [POWER LCD] button.

POWER LCD

≥The [POWER LCD] lamp lights up.

15

VQT0N57