Connections

Before connecting to the projector

zzRead carefully the instruction manual for the device to be connected. zzTurn off the power switch of the devices before connecting cables.

zzIf any connection cable is not supplied with the device, or if no optional cable is available for connection of the device, prepare a necessary system connection cable to suit the device.

zzVideo signals containing too much jitter may cause the images on the screen to randomly wobble or wafture. In this case, a time base corrector (TBC) must be connected.

zzThe projector accepts the following signals: VIDEO, S-VIDEO, analogue-RGB (with TTL sync. Level) and digital signal.

zzSome computer models are not compatible with the projector.

zzWhen using long cables to connect with each of equipment to the projector, there is a possibility that the image will not be output correctly unless a compensator is used.

zzFor details on what video signals the projector supports, see “List of compatible signals”. (Æpages 68-69)

Attention

zzWhen connecting with a video deck, be sure to use the one with a built-in time base corrector (TBC) or use a TBC between the projector and the video deck.

zzIf nonstandard burst signals are connected, the image may be distorted. If this is the case, connect a TBC between the projector and the video deck.

Note

zzUse an HDMI cable that conforms to HDMI standards such as an HDMI High Speed cable. If a cable that does not meet HDMI standards is used, video may be interrupted or may not be displayed.

When connecting the 1080p signal using HDMI, use a cable compliant with 1080p signal. zzThis projector does not support the VIERA Link (HDMI).

Getting Started

ENGLISH - 25