Powering ON/OFF
Powering On the Projector
1111Connect the power plug to the power outlet.
zzEnter Standby status when the <ON(G)/STANDBY(R)> indicator is lighting / flashing in red.
2222Press the < 
> button on the control panel or the remote control.
zzWhen the <ON(G)/STANDBY(R)> indicator lights up in green, the lamp is on.
zz Startup screen is displayed for about 10 seconds, then the image will be projected.
Operation Basic
OR
Note
zzIf the power is disconnected due to the power breaker during projection at the last use, ON(G)/STANDBY(R) indicator will light in green automatically at the next startup and the image will be projected.
Powering Off the Projector
1111Press the < 
> button on the control panel or the remote control.
zzThe following message appears.
zzMessage will disappear after about 30 seconds when there is no operation.
2222Press the < 
> button again.
zzThe projection stops and the <ON(G)/STANDBY(R)> indicator on the projector flashes up in red. (Fan is still spinning.)
3333Wait until the <ON(G)/STANDBY(R)> indicator lights / flashes up in red (The fan stops spinning).
zzThe projector enters standby mode when the <ON(G)/STANDBY(R)> indicator lights / flashes up in red.
Note
zzDo not turn on the power and project images immediately after turning the projector off. Turning on the power while the lamp is still hot may shorten the lamp life.
zzMake sure that the projector is cool enough if you want to pack it for transportation and storage.
30 - ENGLISH