| About Your Projector | |
|
| |
Setting projector ID number to | Using a wired remote control | |
remote control | When multiple projectors are connected as part of the | |
Each projector can be assigned a unique 2 digits ID | system, connect to units with a M3 stereo mini jack | |
commercial cable to simultaneously control multiple main | ||
number, and the remote control 2 digits ID number must | ||
units with a single remote control through the REMOTE 1 | ||
be set to match the intended projector. The default | ||
IN/OUT terminal. It is effective to use the wired remote | ||
setting of the projector ID is ALL. Set the ID of the | ||
control in the environment in which an obstacle stands in | ||
projector in advance from the menu items. | ||
the light path or where devices are susceptible to outside | ||
1.Press the ID SET button. | ||
light. | ||
Displays the projector ID number on the screen. | ||
|
2.Within 5 seconds, enter the same number of the required projector by pressing the numeric buttons.
ID number range: 01 - 64
NOTE:
•Do not press the ID SET button accidentally or carelessly because the ID number on the remote control can be set even when no projector is around.
•If you do not enter the 2 digits ID number within 5 seconds after the ID SET button has been pressed, the ID will remain at the number that was set before the ID SET button was pressed.
•Your specified ID will be erased if the batteries of the remote control are left exhausted. When the batteries are replaced, set the same ID number again.
Connect to another projector
M3 stereo mini jack (commercial)
Connect to the remote control wired terminal
Preparation
NOTE:
•Use 2 core shielded cable of length of 15 m or less. If the length of the cable exceeds 15 m (49'2"), the shielding of the cable may not be sufficient and the remote control may not work.
