Setting up
Removing and attaching the projection lens
Removing the projection lens | Attaching the projection lens to |
from the projector | the projector |
1.Switch off the POWER button on the projector.
2.Rotate the lens cover counterclockwise and remove.
1. Switch off the POWER button on the projector.
When the lens cover is attached, rotate counterclockwise and remove.
2.Align the guide of the projection lens with the guide groove in the projector, and then insert the lens.
Lens cover
3.While pressing the lens release button, rotate the projection lens counterclockwise, and remove the projection lens.
Lens release button | Projection lens |
|
NOTE:
•Do not touch the lens signal contact. Dust or dirt may cause defective contact.
•Do not touch the surface of the projection lens with your bare hands.
•Store the replaced lens where it will be free from vibration and impact.
3.Rotate the projection lens clockwise until it clicks into place.
4.Place the lens cover back to the projector, and rotate clockwise to attach.
NOTE:
•Make sure the projection lens is attached securely by rotating the projection lens counterclockwise.
Getting Started
