Replacement
Replacing the Lamp unit
Before replacing the Lamp unit
Turn off the POWER switch of the projector in proper way and disconnect the power plug from the wall outlet. Wait for more than 1 hour and make sure the lamp unit and the surroundings are cooled enough. Prepare a
Contact the dealer to purchase a replacement lamp unit
CAUTION:
• The lamp may explode or shorten the lamp life by shocks or chipping damage.
NOTE:
•Prior to replacing the lamp unit, allow it to cool down to prevent the risk of burns, damage and other hazards.
•Do not attempt replacement with an unauthorized lamp unit.
When to replace the lamp unit
The lamp unit is consumable and the brightness decreases by duration of usage. The LAMP1/LAMP2 indicators will inform you of the replacement timing at 1 800 hours, and at 2 000 hours, the projector will be turned off. Those figures are rough guidance and might be shortened by the usage conditions, characteristics of the lamp unit, environmental conditions, and so on. You can check the duration of usage time using LAMP1/ LAMP2 of STATUS in the PROJECTOR SETUP menu.
On screen | LAMP indicator |
REPLACE LAMP
Indication
LAMP
| “REPLACE LAMP” is displayed on the upper left |
|
Over 1 800 hours | of the screen for 10 minutes. Press any button to |
|
| clear the screen, or disappears after 10 minutes. | Lights in red |
| “REPLACE LAMP” is displayed on the upper left | |
Over 2 000 hours | of the screen, and it will stay until you respond. |
|
| To clear the screen, press any button. |
|
CAUTION:
•If you keep using the lamp unit after 2 000 hours, it cause the damage of the projector. Automatically the projector will be powered off after 10 minutes.
NOTE:
•The guide times, 1 800 and 2 000 hours, are rough estimates based on certain conditions and are not a guaranteed time.
•For more information about the lamp unit, such as guaranteed time, see the instructions which is provided with the lamp unit.
Maintenance
