| Precautions with regard to safety |
|
|
Do not reach for the openings beside the optical | Replacement of the lamp unit should only be carried |
lens, during horizontal or vertical movements of the | out after it has completely cooled off. |
lens. | Failure to observe this may cause burns. |
Failure to observe this may cause injury. |
|
We are constantly making efforts to preserve and maintain a clean environment. Please take non repairable units back to your dealer or a recycling company.
Important Information
Cautions when transporting
Do not subject the projector to excessive vibration or shocks.
The projector lens need to be handled with care.
Cover the lens with the lens cover when transporting the projector.
When transporting the projector, hold the body at the bottom securely.
Do not hold the adjuster legs or the top cover to move the projector, as this may damage the projector.
Be sure to always remove the lens during transport.
The projection lens is susceptible to vibrations and impacts.
Cautions when installing
Avoid setting up in places which are subject to vibration or shocks.
The internal parts can be damaged, which may cause malfunctions or accidents.
Avoid setting up in places which are subject to sudden temperature changes, such as near an air conditioner or lighting equipment.
The life of the lamp may be shortened or the projector may be turned off. See “TEMP indicator” on page 28.
Do not set up the projector near
The projector may be subject to electromagnetic interference.
If installing the projector to the ceiling, ask a qualified technician to carry out all installation work.
You will need to purchase the separate installation kit (Model No.
If using this projector at high elevations 1 400 - 2 700 m (4 593 - 8 858 ft) sea level, set the HIGH ALTITUDE MODE to ON.
Failure to observe this may result in malfunctions or the life of the lamp or the other components may be shortened.
Be sure to install the projection lens cover after installing the projection lens.
If this not done, dust will collect inside the projector and problems with the projector will result.
Cautions on use
In order to get the best picture quality
Draw curtains or blinds over any windows and turn off any lights near the screen to prevent outside light or light from indoor lamps from shining onto the screen.
In rare cases, wafture can occur on the screen affected by the warm air from the exhaust port depending on the environment. Make sure that there is no equipment in front of the set which will recirculate the exhaust air from the set or other nearby equipment.
Do not touch the surfaces of the lens or the front glass with your bare hands.
If the surface of the lens becomes dirty from fingerprints or anything else, this will be magnified and projected onto the screen. Moreover, when not using the projector, close the front panel cover.
