Setting up
Removing and attaching the projection lens
Removing the projection lens from the projector
1.Switch off the POWER button on the projector.
2.Rotate the lens cover counterclockwise and remove.
Lens cover
Attaching the projection lens to the projector
1.Switch off the POWER button on the projector.
When the lens cover is attached, rotate counterclockwise and remove.
2.Align the guide of the projection lens with the guide groove in the projector, and then insert the lens.
3. While pressing the lens release button, rotate the | 3. Rotate the projection lens clockwise until it clicks into |
projection lens counterclockwise, and remove the | place. |
projection lens. |
|
Getting Started
Lens release button | Projection lens |
|
NOTE:
•Do not touch the lens signal receiver. Dust or dirt may cause defective contact.
•Do not touch the surface of the projection lens with your bare hands.
•Store the replaced lens where it will be free from vibration and impact.
4.To attach the slot, align the slot of the lens cover (see *1) with the arrow tip located on the body of the projector (see *2). Rotate clockwise until it reaches the arrow’s end mark 
(see *3) to attach.
Lens cover
*3
*2 
*1
NOTE:
•Make sure the projection lens is attached securely by rotating the projection lens counterclockwise.
