Panasonic PT-FW300U, PT-FW300NTU manual Read this first, Minimum required setting screen

Read this first

Minimum required setting screen

When you start the projection for the first time, the minimum required setting screen for projection will be displayed.

	INITIAL SETTING	INSTALLATION
1.	Select the required language setting by pressing	Select the required installation method.
	I H, then press the ENTER button.		Setting on a desk/floor and
	INITIAL SETTING	FRONT/DESK
			projecting from front
		FRONT/CEILING	Mounting on the ceiling and
			projecting from front
		REAR/DESK	Setting on a desk/floor and
			projecting from rear
		REAR/CEILING	Mounting on the ceiling and
	ENGLISH		projecting from rear
		SCREEN FORMAT
	PLEASE SELECT LANGUAGE	Select the required screen format by pressing I H.
	SELECT	16:10	When project on a 16:10 or 4:3
	ENTER		screen.
		16:9	When project on a 16:9 screen.

Preparation

2.Select the minimum required settings to start the projection.

Press the RETURN button to return to the language setting menu.

Press F G to move through the menu items. Press I H to select the required setting.

Press the ENTER button to complete the setting and start the projection.

INITIAL SETTING

INSTALLATION	FRONT/DESK
SCREEN FORMAT	16:10
SCREEN POSITION	CENTER
HIGH ALTITUDE MODE	OFF

SWITCH TO HIGH ALTITUDE MODE "ON" IF OVER 1400m(4593Ft).

RETURN

SELECT

ENTER

SCREEN POSITION

When SCREEN FORMAT menu is set to 16:9, you can select the menu display position by pressing I H.

LOW	Displays the menu in the lower part
	of the screen.
CENTER	Displays the menu in the middle of
	the screen.
HIGH	Displays the menu in the upper part
	of the screen.

HIGH ALTITUDE MODE

If you use the projector at high elevation, the HIGH ALTITUDE MODE setting need to be ON to set the fan speed high.

OFF	The fan speed is low.
ON	The fan speed is high.

NOTE:

•At 1 400 - 2700 m (4 593 - 8 858 ft) above sea level, the setting must be ON.

•The loudness of fan noise depends on the HIGH ALTITUDE MODE setting.

NOTE:

Once you finish the minimum requirement setting, it will not be displayed again unless the projector is initialized. See “INITIALIZE ALL” on page 43.

You can change the each setting from the main menu. See “Menu Navigation” on page 30.

ENGLISH - 11