Panasonic PT-FW300U, PT-FW300NTU manual Picture menu

PICTURE menu

Remote control Control panel

See “Navigating through the menu” on page 32. See “Main menu and Sub-menu” on page 30.

PICTURE MODE

Depending on the projection environment, you can use these preset parameter settings to optimise image projection. Press I H to cycle through the options.

STANDARD	Setting for a general image
DYNAMIC	Bright and sharp setting
BLACKBOARD	Setting for when projecting on
	a blackboard
NATURAL*1	Reproduces the original color
	of the image
CINEMA*2	Setting for a cinema type
	movie

*1. Selectable when sill image is displayed.

*2. Selectable when moving image is displayed.

NOTE:

•It may take for a while until the image stabilized in the selected mode.

COLOR

You can adjust the color saturation of the projected image. (Available with VIDEO/S-VIDEO/YPBPR/RGBmovie/DVI movie signals only)

LighterDarker

TINT

You can adjust the skin tone in the projected image. (Available with VIDEO/S-VIDEO/YPBPR/RGBmovie/ DVI movie signals only)

More More

reddish greenish

SHARPNESS

You can adjust the sharpness of the projected image.

Less	More
sharp	sharp

CONTRAST

You can adjust the contrast of the projected image. Adjust the BRIGHTNESS in advance if necessary.

LowerHigher

BRIGHTNESS

You can adjust the brightness of the projected image.

DarkerBrighter

WHITE BALANCE RED

You can adjust the white balance more properly in red color temperature by pressing I H. (Available with RGB/DVI still signals only)

WHITE BALANCE GREEN

You can adjust the white balance more properly in green color temperature by pressing I H. (Available with RGB/DVI still signals only)

WHITE BALANCE BLUE

You can adjust the white balance more properly in blue color temperature by pressing I H. (Available with RGB/DVI still signals only)

Settings

ENGLISH - 33