projector in small rooms where high luminance is not required, it is recommended that you set the “LAMP POWER” to “LOW”.
NOTE:
B“LAMP POWER” cannot be set when no signal is being input.
LAMP RUNTIME
This setting displays the usage time for the lamp unit which is currently being used. When replacing the lamp unit, follow the instructions on page 51, and reset “LAMP RUNTIME” to “0”.
NOTE:
BThe lamp’s operating life varies depending on the usage conditions (such as the “LAMP POWER” setting and the number of times the power is turned on and off).
FUNC 1
FUNC1 
INDEX
[
KEYSTONE 
This assigns a function to the FUNC1 button of the
INDEX
Functions in the same way as the INDEX WINDOW button on the accessory card remote control unit. (page 29)
KEYSTONE
Functions in the same way as when “KEYSTONE” is selected from the “MAIN MENU”. (page 34)
CONTROL KEY
CONTROL KEY | ON |
| [ |
| OFF |
To disable the buttons on the projector, set “CONTROL KEY” to “OFF”. A confirmation screen will then be displayed. Select “OK” by using I or H button. To use the buttons on the projector, set to “ON” by using the remote control unit.
AUTO POW.OFF
If no signal is input to the projector for the duration of the period you set, the projector will return to standby mode. The period can be set from 15 minutes to 60 minutes in 5 minute intervals. If you don't use this feature, set it to “DISABLE”. This feature will not function when using the “FREEZE” function.
POWER MEMORY
POWER MEMORY | ON |
| [ |
| OFF |
This sets the projector’s start up status for when the mains lead is connected.
ON
The projector will start from the same status as when the mains lead was disconnected. If the mains lead was disconnected during projection when the projector was used the last time, projection will start after the mains lead is connected.
OFF
The projector will be in standby mode.
