| LAMP indicator | |
| Displayed for 30 |
|
More than 1 800 hours | seconds. Pressing any |
|
button will clear the | Illuminates red during | |
| display. | image projection and |
| Remains displayed until | standby mode. |
More than 2 000 hours |
| |
any button is pressed. |
|
Lamp unit replacement procedure
NOTE:
BIf the lamp usage time has passed 2 000 hours (when “LAMP POWER” has been set to “HIGH”), the projector will switch to standby mode after approximately 10 minutes of operation. The steps ) to - on the next page should thus be completed within 10 minutes.
#Disconnect the mains lead from the projector by following the procedure on page 24, and check that the area around the lamp unit has cooled down.
$Use a Phillips screwdriver to turn the lamp unit cover fixing screws at the bottom of the projector, and then remove the lamp unit cover.
Lamp unit cover
Lamp unit cover fixing screws
%Use a Phillips screwdriver to loosen the two lamp unit fixing screws until the screws turn freely. Then hold the handle of the lamp unit and gently pull it out from the projector.
Handle
| and maintenance |
Lamp unit fixing screws | Care |
|
&Insert the new lamp unit while making sure that the direction of insertion is correct, and then use a Phillips screwdriver to securely tighten the lamp unit fixing screws.
