FORK/SPRING/CRANK | PROCEDURE 5 |
EXCELERATOR XLT/XLT 2000 FORK/CRANK ASSEMBLY REPLACEMENT (FIGURE 3)
NOTE: Invacare recommends that the following proce- dure be performed by a qualified technician.
1. Note the position of the crank handles.
2.Loosen, but do not remove the two (2) socket screws that secure the crank handles to the existing fork.
3.Slide the crank handles down towards the front wheel.
4.Remove the chain from the crank handles.
5.Remove the crank handles from the existing fork.
6.Remove the two (2) socket screws and half clamp that secure the brake handle to the existing fork.
7.Remove the socket nut on the BACK of the existing fork that secures the brake assembly.
F O R K
/
S P R I N G
STEPS 1, 2, 3, 38, 39
Socket
Screws
Fork
Crank
Handles
STEPS 6, 36
Fork Brake
Handle
Half
Clamp
Socket
Screws
STEPS 7, 8, 35
ForkHardware
Socket
Nut
Brake Assembly
/
C R A N K
STEPS 9, 34
Fork
Road Crown Compensator
STEPS 10, 33
Seat Frame 
Shifter
STEPS 11, 12, 31, 32 |
| |
| ut | Brake |
Lockn | ||
|
| Arm |
|
| |
|
| Clamp |
Brake | He | x Bo | lt |
|
|
| |
Arm |
|
|
|
STEPS 13, 14, 27, 28, 29, 30
Washer - Must
Be Installed
as Shown
Washer
| Front |
Cap Nuts | Wheel |
|
STEPS 16, 17, 24, 25
Fork
Hex
Bolts,
Locknuts
and
Footrest
Footrest
Clamps
STEPS 5, 18, 19, 20, 21, 22, 23, 37
Crank Handles
Top
Nuts
Bearing 
Bottom Bearing
Frame
Fork
FIGURE 3 - EXCELERATOR XLT/XLT 2000 FORK/CRANK ASSEMBLY REPLACEMENT
15
