Invacare Li'l Execelerator manual Excelerator XLT/XLT 2000 Back Angle Adjustment Figure

PROCEDURE 9 BACK/SEAT

B A C K

/

S E A T

3.Remove the locknuts from the threaded studs from seat rails on both sides of seat.

4.Remove seat from seat rails.

5.Reverse STEPS 3-4 to install NEW seat onto seat rails.

6.Reverse STEPS 1-2 to install sliding seat and seat rails onto the seat frame.

Excelerator XLT/XLT 2000 (FIGURE 3)

1.Activate parking brake.

2.Loosen, but do not remove the six (6) socket screws that secure the seat frame to the handcycle frame.

NOTE: There are three (3) socket screws on the right and left side of the handcycle.

3.Loosen, but do not remove the hex bolts and lock- nuts that secure the two (2) seat angle adjustment clamps to the rear seat supports.

NOTE: There is one (1) clamp on the right and left side of the handcycle.

4.Perform one (1) of the following:

A.Moving the seat rearward - While lifting up on the back support tubes, push the seat rearward to the desired position.

B.Moving the seat forward - While pushing down on the back support tubes, pull the seat forward to the desired position.

5.Tighten the six (6) socket screws that secure the seat frame to the handcycle frame securely.

Seat Angle Adjustment Clamps

Seat Frame

	Socket
Socket Screws	Screw
	Handcycle Frame

6.Tighten the hex bolts and locknuts that secure the two (2) seat angle adjustment clamps to the rear seat supports securely.

EXCELERATOR XLT/XLT 2000 BACK ANGLE ADJUSTMENT (FIGURE 4)

1.Activate parking brake.

2.Loosen, but do not remove the four (4) rear socket screws that secure the seat frame to the handcycle frame.

NOTE: There are two (2) socket screws on the right and left side of the handcycle.

3.Loosen, but do not remove the hex bolts and lock- nuts that secure the two (2) seat angle adjustment clamps to the rear seat supports.

NOTE: There is one (1) clamp on the right and left side of the handcycle.

4.Perform one (1) of the following:

A.Increasing Back Angle - While lifting up on the back support tubes, pull the seat upward to the desired position.

B.Decreasing Back Angle - While pushing down on the back support tubes, push the seat down to the desired position.

5.Tighten the three (3) socket screws that secure the seat frame to the handcycle frame securely.

6.Tighten the hex bolts and locknuts that secure the two (2) seat angle adjustment clamps to the rear seat supports securely.

Seat Angle Adjustment Clamps

Seat

FIGURE 3 - SLIDING SEAT ADJUSTMENT -	Socket	Handcycle Frame
	Screws
EXCELERATROR XLT/XLT 2000

FIGURE 4 - EXCELERATROR XLT/XLT 2000 BACK

ANGLE ADJUSTMENT

24