FOOTREST | PROCEDURE 11 |
EXCELERATOR XLT/XLT 2000 FOOTREST AND LEG GUARD REPLACEMENT (FIGURE 2)
Footrest
1.Note the position of the existing footrest.
2.Remove the hex bolt and locknut that secure the ex- isting footrest to the fork.
3.Remove the existing footrest from the clamp on the fork.
4.Slide the new footrest into the clamp on the fork to the position noted in STEP 1.
5.Reinstall the hex bolt and locknut. Tighten securely.
6.Repeat STEPS
Leg Guard
1.Loosen the two (2) allen screws on each mount- ing clamp.
Footrest Replacement
Fork 
Clamp,
Hex Bolt
and
Locknut
Footrest
Leg Guard Replacement
F O O T R E S T
2. | Position each mounting clamp onto the fork under |
| Fork |
| the brake cable as shown in FIGURE 2. |
|
|
NOTE: The leg guard should surround, but not touch |
| Brake | |
the REAR of the front tire. |
| ||
3. | Tighten the two (2) allen screws on each mounting |
| Cable |
|
| ||
| clamp securely. | Rear of |
|
|
| Front | Allen |
|
| Tire | Screws |
Mounting
Clamp
Leg Guard
FIGURE 2 - EXCELERATOR XLT/XLT 2000 FOOTREST
AND LEG GUARD REPLACEMENT
27
