OPTIONS | PROCEDURE 13 |
This Procedure includes the following:
Water Bottle Installation
Tow Bar Installation
Safety Light Installation
Computer Installation
Seat Positioning Strap Installation
Horizontal Handles
Gloves
Safety Flag
Safety Helmet
WARNING
After ANY adjustments, repair or service and BE- FOREuse,makesureallattachinghardwareistight- ened securely - otherwise injury or damage may result.
WATER BOTTLE INSTALLATION (FIGURE 1)
1.Secure the black water bottle mounting tube to the seat frame using the hardware provided.
NOTE: Make sure that the water bottle mounting bracket mounting holes are facing downward.
2.Attach the water bottle mounting bracket to the black mounting tube using the hardware provided.
3.Push water bottle into mounting bracket until secure.
TOW BAR INSTALLATION (FIGURE 1)
1.Attach the tow bar mounting brackets to the rear chair frame of the Excelerator using the hardware provided.
NOTE: Make sure that the mounting hardware is cen- tered on the rear chair frame.
2.Insert tow bar into mounting bracket and secure with hardware provided.
REAR SAFETY LIGHT (FIGURE 1)
Operating the Safety Light
1.Press GREY button for ON/OFF.
2.Remove lens cover and slide Black switch back and forth for pulse or constant mode.
Mounting the Safety Light
1.Open clip on back of safety light.
2.Place clip over back upholstery fastening flap and release.
COMPUTER INSTALLATION (FIGURE 1)
1.Install metal plug onto spoke of front wheel approxi- mately
2.Align metal plug with fork assembly.
3.Secure sensor to fork using hardware provided.
NOTE: Slot in sensor MUST align with metal plug for mile- age etc. to be registered on the computer.
4.Remove one (1) of the chain guard screws and at- tach the computer mounting bracket.
5.Snap computer into mounting bracket.
SEAT POSITIONING STRAP
INSTALLATION (FIGURE 1)
1.Secure seat positioning strap to back canes using hardware provided.
HORIZONTAL HANDLES (FIGURE 1)
1.Remove existing handles and replace as shown in FIGURE 1.
TRI-PIN QUAD HANDLES (FIGURE 1)
1.Remove existing handles and replace.
2.Loosen socket screws and adjust.
GLOVES (FIGURE 1)
1.Wrap palm loop around horizontal handle (using top slot only) and secure by attaching velcro strips to- gether.
O P T I O
N S
WARNING
Operation of the Excelerator is subject to all traf- fic rules and regulations. (This may include the use of a safety light and reflectors for dusk/night riding.)
Batteries
1.Remove the lens cover.
2.Insert the AAA batteries with correct polarity (+ or
3.Reinstall lens cover.
2.Run velcro strip (back of hand) through bottom slot on palm and over back of hand until tight. Secure by attaching velcro strips together.
3.Reattach glove strips to back of glove.
SAFETY FLAG INSTALLATION (FIGURE 1)
1.Mount safety flag in holder secured to back tube on bike frame.
33
