Invacare Li'l Execelerator, Excelerator XLT manual Bearing Play Adjustment Figure

PROCEDURE 12 OPERATION

O P E R A T I O N

Bearing Play Adjustment (FIGURE 6)

NOTE: Refer to the SAFETY INSPECTION CHECKLIST to determine how often bearing play adjustment is nec- essary.

NOTE: This adjustment is required only if there is some play in the hand crank in a SIDE TO SIDE motion.

NOTE: There will be some play in a forward/rearward motion.

1.Slightly tighten self-locking nut on the left side (sitting in the handcycle) of the hand crank. DO NOT over- tighten.

NOTE: Overtightening the self-locking nut will cause the gears to engage improperly after shifting.

Self-Locking Nut

Hand

Crank

FIGURE 6 - MOUNTAIN DRIVE OPTION -

BEARING PLAY ADJUSTMENT

Adjusting Gear Shift Push Button (FIGURE 7)

WARNING

Incorrect adjustment of gear shift push button may reult in a failure of the coaster brake, pos- sibly causing injury and or damage.

1.Loosen, but do not remove the allen set screw in the middle of the gear shift push button.

2.Turn in the gear shift push button approximately two

(2) revolutions.

3.Push the gear shift push button IN.

4.Move the hand crank slightly until the switch posi- tion engages audibly.

5.Turn the gear shift push button until it is flush with the hand crank.

NOTE: Make sure there is some play underneath the button.

6.Securely tighten the allen set screw in the middle of the gear shift push button.

Hand Crank

Gear Shift

Push Button

Allen Wrench

FIGURE 7 - MOUNTAIN DRIVE OPTION -

ADJUSTING GEAR SHIFT PUSH BUTTON

32