Panasonic SC-PT850W, SC-PT550 Operating the television, Changing the main unit and remote control

Operating other equipment (continued)

Operating the television

You can use the remote control to operate a Panasonic television.

Aim the remote control at the television.

To switch the television on or off

To switch the television’s video input mode

Adjust the volume

To play audio from your television through your home theater system

Preparation

Connect your equipment referring to “Connect to the various television terminals” (\ page 13).

Press [EXT-IN] to select “AV∗”/“AUX” as the source. Then reduce the volume on the television to its minimum, and control the volume on this main unit.

Note

•The remote control may not work properly with some models.

•You can enjoy 5.1-channel surround sound when you turn on Super Surround (MOVIE, MUSIC) (\ page 33).

Operating the cable TV box, digital broadcasting or satellite receiver

This unit can decode the surround signals received through cable TV box, digital broadcasting or satellite broadcasts. Refer to your equipment’s operating instructions for details. Only Dolby Digital and PCM can be played with this connection.

Rear panel of this main unit

To DIGITAL OUT

OPTICAL

PCM FIX Mode

Press and hold [3]. (remote control)

PFIX ON: Select when receiving only PCM signals.

PFIX OFF (factory preset): Select when receiving Dolby Digital and PCM signals.

Dynamic Range Compression

Press and hold [2 ].

DRC ON: Adjusts for clarity even when the volume is low by compressing the range of the lowest sound

Optical digital audio cable (not included)

• Do not bend sharply when connecting.

IN

level and the highest sound level. Convenient for late night viewing. (Only works with Dolby Digital)

DRC OFF (factory preset)

OTHER OPERATIONS ENGLISH

To select “D-IN” (Digital In) as the source, press several times.

USB → AV∗ → AUX → D-IN(Digital In)

MUSIC P.

When you select “D-IN” as the source, you can select the following sound effects. (These functions only work with Dolby Digital or PCM, excluding Audio Mode, which only works with Dolby Digital Dual Mono.)

Audio Mode

Press and hold [5].

AUDIO ST, AUDIO L, AUDIO R (“AUDIO L” and “AUDIO R” only appear when the signal is Dolby Digital Dual Mono.)

Dolby Pro Logic II (\ page 33)

Press [ŸPLII].

Note

Audio that is input through the OPTICAL IN terminal cannot be output through the HDMI terminal.

Changing the main unit and remote control

The remote control and main unit are factory-set to “REMOTE 1” mode.

If your remote control affects other equipment during operation, you can switch to operate in “REMOTE 2” mode.

To switch to “REMOTE 2” mode

1 While pressing and holding [ ] on the main unit

“REMOTE 2” appears on the main unit display.

2 To operate in “REMOTE 2” mode

+

(Press and hold for 2 seconds)

RQTX0038	∗
		For Continental Europe

40

To return to “REMOTE 1” mode

Perform steps 1 and 2 but use [1] instead of [2] for both steps. (“REMOTE 1” appears on the main unit during step 1.)

The remote control cannot work with the main unit if their modes are different.

“REMOTE 1” or “REMOTE 2” appears on the main unit display when you operate the remote control.

•If “REMOTE 1” appears (The main unit is in “REMOTE 1” mode.)

Press and hold [ENTER] and [1] on the remote control for at least 2 seconds.

•If “REMOTE 2” appears (The main unit is in “REMOTE 2” mode.)

Press and hold [ENTER] and [2] on the remote control for at least 2 seconds.

Note

You can still operate a television using the remote control (\ see above) even after switching the mode.

RQT8043