Setup 1 Charging

Insert the battery into the unit and charge it.

1 Set the mode dial to [OFF].

The unit runs on AC power (status indicator lit red) and the battery cannot be charged when the mode dial is set to any position other than [OFF].

2 Opendoor. the card/battery

Slide the lock to the OPEN side and lift the projection with a finger to open.

OPEN

Projection

3 Insert the battery.

Ensure that battery is oriented correctly, and push it into the compartment in the direction of the [▲] until it snaps into place and it is locked by the lever.

(To remove the battery, press the lever downward.)

4 Closedoor. the card/battery

Press [ ] until hearing the door snap closed.

5 Connect the AC adaptor (supplied).

Connect the AC cable to the AC adaptor and then to an AC outlet.

To AC outlet

Lever

Press here.

 

 

OPEN

Check that the red marker of the lock is no longer visible.

AC adaptor

AC cable

Small gap here.

Do not use the AC cable and AC adaptor of this unit with other devices. Also, do not use the AC cables and AC adaptors of other devices with this unit.

22 VQT1M21

Page 22
Image 22
Panasonic SDR-SW20P Setup 1 Charging, Set the mode dial to OFF, To AC outlet Lever Press here, AC adaptor AC cable*