●While the card access lamp is lit, reading, recording, playback, deletion or other processing is being executed. Performing the following operations while the lamp is lit may damage the SD card and its content and the unit may not function properly.
• Switching off power
• Removing battery or AC adaptor
• Opening card/battery door and removing SD card
• Rotating the mode dial
• Shaking or impacting the unit
Card access lamp
VQT1M21

Setup 3 Inserting/Removing SD

cards (sold separately)

SD cards are sold separately. Preparations: Set the mode dial to [OFF].

(Check that the status indicator is out.)

Inserting or removing an SD card with the power ON may damage the unit and destroy data on the card.

1 Opendoor. the card/battery

Slide the lock to the OPEN side and lift the projection with a finger to open.

2 Insert/Removecard. the SD

•To insert:

Face the label upwards and slide the card in straight until hearing it catch.

•To remove:

Press the center of the SD card and pull the card out straight.

3 Closedoor. the card/battery

•Press [ ] until hearing the door snap closed.

•If the door does not close completely, remove the SD card, check its orientation and reinsert it into the slot.

OPEN

Projection

Place label upwards.

Press here.

OPEN

Check that the red marker of the lock is no longer visible.

25

Page 25
Image 25
Panasonic SDR-SW20P operating instructions Setup 3 Inserting/Removing SD, Insert/Removecard. the SD