Select the input signal, INPUT1 INPUT2 INPUT3 | Panasonic TH-42PHW6

Power On/Off and input signal selection

Select the input signal

- +

INPUT MENU - VOL + ENTER

INPUT

SURROUND

VOL

NR

INPUT

Press the INPUT button to select the input signal to be played back from the equipment which has been connected to the Plasma Display.

Input signals will change as follows:

INPUT1 INPUT2

INPUT3

PC IN

Notes:

(1)Input terminal will not be selected if the terminal board is not installed into the SLOT.

(2)Select to match the signals from the source connected to the component/RGB input terminals. (see page 23)

(3)In 2 screen display, the same input mode cannot be selected for the main picture and sub picture.

Selecting the On-Screen Menu Language

INPUT

SET UP

Press to display the Set Up menu.

Press to select the OSD Language.

SURROUND

VOL

NR

PICTURE

SOUND

SET UP

MULTI

Press to select your preferred language.

Selectable languages

English(UK)

Deutsch

Français

Italiano

Español

ENGLISH(US)

.......(Chinese)

Setup
Component/RGB-in select	RGB
	RGB
Input label	RGB1
Signal
Screensaver
Power save	Off
Standby save	On
Power management	Off
OSD Language	English (UK)

13

Image 13

Panasonic TH-42PHW6 manual Select the input signal, Selecting the On-Screen Menu Language, INPUT1 INPUT2 INPUT3, Englishus

Contents

High Definition Plasma Display Operating InstructionsEnglish Model No. TH-42PHW6 Important Safety Notice Table of Contents Setup Safety PrecautionsWhen using the Plasma Display If problems occur during use Cleaning and maintenanceElectric shocks can result if this is not done Trademark Credits Accessories Supply AccessoriesRemote Control Batteries Speakers ConnectionsTerminals L Speakers Terminals R AC cord connection see AC cord fixing PC Input Terminals connection Signal Names for D-sub 15P ConnectorSDA HD/SYNC Command Installing the ferrite core Large sizeSerial Terminals connection Communication parameters DVD AV & Component connectionVideo VCR Camcorder VCR Basic Controls Off Power On/Off Power On/Off and input signal selectionConnecting the plug to the Wall Outlet AC cord connection Selecting the On-Screen Menu Language Select the input signalINPUT1 INPUT2 INPUT3 Englishus On-Screen Menu Displays To Signal screen for RGB see To Signal screen for Component seeTo setup Screensaver see page 20 Aspect Controls Adjusting screen Adjusting Picture Pos./SizeHelpful Hint N / Normalise Normalisation Normal Picture AdjustmentsDynamic Cinema Mute Sound Adjustment Start setting Mode selectionScreensaver For preventing after-images Reversal / Scroll selection This function may be applicable to the non-picture area Side Panel Adjustment Customizing the Input labels Reduces power consumptionPress to change the Input label INPUT3/VIDEO3/COMPONENT3/RGB3/PC3/DVD3/CATV3/VCR3/STB3 Component/RGB-in select Setup for Input Signals3D Y/C Filter For Ntsc AV images RGB Cinema reality Colour system / Panasonic AutoIf the picture image becomes unstable PAL Secam Ntsc Sync Setting RGB sync signalFreq. kHz/V-Freq. Hz Displays the H Horizontal/V Vertical frequencies Plasma Display panel Symptoms Check Troubleshooting Applicable input signals for PC Input D-sub 15P ∗ Mark VIDEO/COMPONENT/RGB/PC Input SignalsPAL60 Customer’s Record Specifications