Panasonic TQB4GC0625, TH-L42E30G, TH-L42E30S manual Network Digital TV Other

Frequently Asked Questions

HDMI

Network

Digital TV

Other

Problem	Actions
	•Set the sound setting of the connected equipment to “2ch L.PCM”.
Sound is unusual	•Check the [HDMI1 / 2 / 3 / 4 Input] setting in the Sound Menu.
	(p. 31)
	•If digital sound connection has a problem, select analogue sound
	connection. (p. 70)
Pictures from external	•Check the HDMI cable is connected properly.			(p. 61, 67 - 68)
equipment are unusual	•Turn the TV and equipment Off, then turn them On again.
when the equipment is	•Check an input signal from the equipment.			(p. 71)
connected via HDMI	•Use equipment compliant with EIA/CEA-861/861D.
	•Check the LAN cable or Wireless LAN Adaptor is connected properly.
Cannot connect to the	(p. 52)		(p. 53 - 56)
	•Check the connections and settings.
network	•Check the network equipment and network environment.
	•If the problem persists, consult your Internet Service Provider or
	telecommunications company.
Cannot select the	•Is the media server prepared?	(p. 51)
file during DLNA
operations	•Check applicable data format.	(p. 73 - 74)
Cannot operate	•Check the connections and settings.		(p. 53 - 56)
VIERA Connect	•The server or connected line might be busy now.

•Due to the digital reception technologies involved, quality of the Digital TV signals may be relatively low in some cases, despite good reception of Analogue TV channels.

•Install an aerial individually for the TV and VCR (or use a splitter).

TV			(Individual aerial)
Unable to receive
		Aerial Output
signals with a			Splitter
high-performance
aerial	Aerial		Aerial Input
	Input	Aerial Output
VCR	terminal		(Individual aerial)

•Check “Digital TV Signal Condition” (p. 36). If “Signal Quality” is Interference or frozen / displayed in red, check aerial. If problem persists, consult your local

disappearing image in	Panasonic dealer.
Digital TV	•Turn the TV off with the Mains power On / Off switch, then turn it On
	again.
The TV goes into	•Auto power standby function is activated.
Standby mode	•The TV enters Standby mode about 30 minutes after analogue
	broadcasting ends.
	•Are the batteries installed correctly? (p. 8)
The remote control	•Has the TV been switched On?
does not work or is	•Point the remote control directly at the front of the TV (within about
intermittent	7 m and a 30 degree angle of the front of the TV).
	•Situate the TV away from sunshine or other sources of bright light not
	to shine on the TV’s remote control signal receiver.

78