Picture Menu Operation
Colour temperature The Colour temperature control allows you to change the White balance setting between Standard, Warm and Cool.
Use the 
or 
buttons to switch between settings.
The | |
| system is designed to reduce picture |
| noise during poor quality reception |
| conditions. Pushing the left or right |
| buttons will change the setting between |
| Off, Strong, Weak and Auto. |
| Use the or buttons to switch between |
| settings. |
Scan mode | The Scan mode control allows you to |
| change the Picture refresh setting |
| between 75/883i, 100Hz and Progressive. |
| Use the or buttons to switch between |
| settings. |
Picture menu
Contrast
Brightness
Colour
Sharpness
Colour Temperature 
Scan mode | 75 / 833i |
Picture menu |
|
Contrast |
|
Brightness |
|
Colour |
|
Sharpness |
|
Colour Temperature | Standard |
| |
Scan mode | 75 / 833i |
75/883i | This mode gives a |
|
|
|
|
|
| ||
| faster refresh rate and | Standard | ||
| more lines than a | |||
| standard television. | Auto | ||
100Hz | 100Hz will give a |
|
|
|
| steady picture for most |
|
|
|
| signals. |
|
|
|
Progressive | Recommended when receiving NTSC signals. |
|
|
|
NOTE: | The scan mode function is not available when Picture in Picture | |||
| is being used. |
|
|
|
Switching is also possible using the 
button on the remote control.
Notes:
We recommend that you set the Scan mode to Progressive when viewing a PAL 60 or NTSC transmission. When viewing a PAL transmission (other than PAL 60) with the Scan mode set to Progressive, the screen will flicker. This is not a fault.
The Multipip function will not operate when a Progressive signal is used.
Normalisation
Pressing the Normal ( 
) Button on the remote control, when the Picture Menu is displayed will return all picture settings to the factory preset levels. This is called “Normalisation”.
Normalisation will not occur if the Picture Menu is not displayed when the Normal ( 
) Button is pressed.
