Panasonic TX-86PW200A manual Nec, Orion Aiwa, Fujitsu Sanyo, Hitachi, Sharp JVC, Sony

Remote Control VCR/DVD Operation

Manufacturers’ Code Settings

This remote control has been designed to work with a variety of VCRs and DVD players. In order for this to occur, the setting for the VCR or DVD must be programmed into the Remote Control.

1.To set a VCR, slide the remote control VCR-DVD switch to VCR.

To set a DVD, slide the remote control VCR-DVD switch to DVD.

2.Push the remote control VCR-DVD Power Button and keep it Pushed.

3.Enter the Manufacturer’s two-digit code number using the remote control Number Buttons (The codes are shown below).

4.Push the STOP button .

5.Release the remote control VCR or DVD Power Button .

6.Check the operation of the VCR or DVD. If it does not operate correctly, repeat steps 1 to 5 and use an alternate code (if there is one).

VCR CODES

Manufacturer	Code	Manufacturer	Code
Panasonic /	10, 11, 12, 13	NEC	40, 41, 42, 43
National		ORION	45, 46
AIWA	15, 16	Philips	50
FUJITSU	20	SANYO	55, 56, 57, 58
HITACHI	25, 26, 27	SHARP	60, 61
JVC	30, 31, 32	SONY	65, 66, 67
MITSUBISHI	35, 36	TOSHIBA	70, 71

DVD CODES

ManufacturerCode

Panasonic70

NOTES:

1.If the batteries are removed from the remote control the Manufacturer’s codes are lost and must be reprogrammed.

2.The list of manufacturer’s codes is given as a guideline only. Panasonic cannot guarantee that any other manufacturer’s product will work with this remote control.