• When using PoE (Power over Ethernet: IEEE802.3af compliant)
Connect a LAN cable (category 5 or better) between a PoE device (such as a PoE hub) and the network connector of the camera.
Important:
•Use all of 4 pairs (8 pins) of the LAN cable.
•Maximum length of an Ethernet cable that can be connected is 100 m.
•Make sure that the PoE device in use is compliant with IEEE802.3af standard.
•When connecting both the 12 V DC power supply and the PoE device for power supply, PoE will be used for power supply.
•When disconnecting the LAN cable once, connect the cable again after 2 seconds or more from the disconnection. When the cable is connected before 2 seconds passed, the power may not be supplied from the PoE device.
•Refer to the provided slip (Recommended network devices for PoE (IEEE802.3af compli- ant) connection with the
v Connect a LAN cable (category 5 or better) to the network connector on the rear.
|
| FOCUS | LINK | |
|
| ASSIST | ||
POWER | SD |
|
|
|
| CARD |
|
|
|
AUDIO OUT | MIC IN |
|
| |
12V | IN |
| EXT I/O | MONITOR OUT |
24V | IN |
|
|
|
C | B | A | 1 2 3 4 |
Ethernet cable
bConnect an external device to the EXT connector.
Remove 9 mm - 10 mm of the outer jacket of the cable from the external device and twist the core of the cable to prevent a short cir- cuit.
Specification of cord (wire): AWG #22 - #28 single core, twisted
*Make sure that the exposed core wires are completely hidden after inserting the cable.
Cut
Approx. 9 mm - 10 mm
Important:
•Do not connect 2 wires or more directly to a termi- nal. When it is necessary to connect 2 wires or more, use a splitter.
•Connect an external device with verifying that the ratings are within the specification below.
qGND
w AUX OUT
(AUX output terminal)
1 2 3 4
r ALARM IN (Alarm input terminal)
eALARM OUT
(Alarm output terminal)
<Ratings>
qGND
wAUX OUT
Output specification: Open collector output (Maximum applied voltage: 20 V DC)
Open: 4 - 5 V DC by internal
Close: Output voltage of 1 V DC or less (50 mA or less)
eALARM OUT
Same as AUX OUT
rALARM IN
Input specification:
OFF: Open or 4 - 5 V DC
ON: Make contact with GND (drive current: 1 mA or more)
25