ParaBody 950102 manual Step F & H

Pec Dec Cable Assembly Instructions

Use this procedure to assemble the pec dec cables of the ParaBody 950ST

Step C

Step F & H

Step G

I

	1318 x ~-3/4."
	0
Step D	__ E

Step 1

A.In this order, route tthe threaded end of the let cable (107) through the top boom (20), the (15), and the large hole in the pec guTde rod support

B.Screw the threaded end of the laf cable (107) approxmately 3/4" into the end of the selector shaft C113) and fighfen, jam nut securely as shown.

C, Securely assemble three 3_-,1/2" pulleys (111) into the slots of the top boomC20) using three 3/8 2-3/4" bolts C99), six 3/8' Flange Spacers (74), and three 3/8" nylock nuts (83). (Note: Loop

cable around each pulley prior to inserting it into the slot.)

Securely assemble two 3-1/2" pulleys (111) into the slots of the base (15) using two 3./'8

2-3/4" bolts (99), four 3/8"" Flange Spacers (74), and two 3/8" nylock nuts (B3). (Note: Loop cable around each pulley prior to inserting if into the slot.)

Secu'rely tighten the bolts of the pec guide rod support (43) and fop boom(ZO) connect'ion at

time. (Note: Center the pec guide rod support horizantally and vertically before tightening.

Apply two 1" x 1" gll~des (60). to the floating pulley (30), as shown.

Securely assemble one 4-1/Z" pulle~' (.110) to the flpafing pulley stop (32) using one 3/'8 x 2-.3/4" bolt (99~), two 3/8" flange spacers (.74), and one 3/8" nylock

Securely assemble one 4-1/2" pulley (110).to the floofin 9 pulley (30) using one 3/B x 2" half

(100), two 3/8" washers C78), and one 3/8 nylock nut ~83). Loop cable around pulley and place the floating pulley (30) onto the floating pulley stop (32).

18