ParaBody 950102 manual X ~-~/~~o=~~ss. ~.~ ~/s ~.g~ =p~=~7~, ~ o~ ~/s ~o=kn=~ S~

Press Station Cable Assembly Instructions

Use this procedure to assemble the press station cable of the ParaBody 950!~T

Step 1

A.Secure the ball end of the press cable .(105.) and two. ,3-1/2"pul!ey~. (111) to the. swive, I p, ulley, bracket (41) using two 3/8 x 2" bolts (,100), four 3/8" washers (78), and two 3/8" nylocK (Note: Loop the cable around the pulley prior to inserting it into ,the swivel pulley brclcket.)

B.Route the threadec~l end of the press cable C105) through the large hole in !,he press frame C17)

and. secure to.the front slot of t.he press arm adiusf C23) using one 3-1/2 pulley (111),

3/8 x ~-~/~~o=~~ss). ~.~ ~/s" ~.g~ =p~=~(7~), ~ o~ ~/s" ~o=kn=~ (S~).

Loop ~he cable ow=r the pulley prior Jo inse~ing it into the slot,)

C.Sec~rs ~he press cable {l~).o.d o.e 4-1/2" p~lley (110) fo,~fhe press bose (13). u,~.g o.e 2-3/4" bolt (99), two 3/B flange spacers (74), and one 3/B nylock nu~ (83). CNote: Loop cable under the pulley prior fo inserting it in~o the slot,

Do Secure the press ,cable C105) and one 3-1/2" pulley

(111)to the rear slot of the press arm adjust

using one 3/8 x 2-3/4" bo}t (99), two 3/8" flange spacers (74), and one 3/8' nylock nut (B3). (Note:" Loop the cable over the pulley prior to inserting if

into the slot.)