Step 6
A.SlTde two hinge tabs (73) onto two 3/8 x 1" bolf;~ (97), and
should face upward.)
the wolff sleeve (39) and securely attach press seat pl:ld (49) two 3/8" washers (78). (Note: The "hinge" part of the hinge
'B. Slide the right back pad angle (2) and left back pad angle (5) onto the wolff sleeve (39) attach the press back pad (50) using four 3/8 x 1" bolts (97), and four 3/B" wash=:rs
C.Secure the 1/2 x 2 x
Secure nuts, then back off 1/4
D.Secure the 1/2 x 2 x
E.Apply one rubber Ibumber (56) contact with the rear bolt.
plate (116) to right back pad angle (2) and the left back pad angle (87), two 1/2" washers (79), and two 1/2" low heigh! nyIock
.turn.)
plate (116) fo bushing in press base (15) using 1/2 x 6- 1/ 2" nut (82). Secure nut, then back off 1/4 turn.
to the back of the press back pad (50) where the .pa=~ comes
10
