Paradyne SLV 9128, 9128-II technical manual

11.Set up SNMP local management (see Setting Up Local Management at the Central Site on page 13).

12.Set up the modem, and the Call Directories if trap dial-out is desired (see Setting Up the Modem on page 14).

13.If the unit is equipped with an ISDN DBM, set up the DBM (see Setting Up the ISDN DBM on page 16).

14.If SNMP traps are wanted, set up managers, select the desired traps, and configure trap dial-out if desired (see Configuring SNMP Trap Managers and Trap Dial-Outon page 18).

15.Save the configurations.

16.Verify the entire path from the remote unit to the NMS is functioning (see Verifying the End-to-End Path on page 20).

17.If the DSX-1 interface will be used, install the DSX-1 cable (see Connecting to DSX on page 21). Time slots for the DSX-1 interface will need to be assigned to the network interface (see Assigning DSX-1 Time Slots to the Network Interface in Configuration of the User’s Guide).

18.Install the modem cable (see Connecting the Modem on page 21).

19.If the unit is equipped with an ISDN DBM, install the ISDN DBM cable (see Connecting to ISDN on page 21).

20.If the FrameSaver SLV 9128-II will use its Ethernet port for management, install the Ethernet cable (see Connecting to Ethernet on page 22).

21.Install the DTE cables (see Connecting to a DTE on page 22).

22.Verify that data is being received (see Verifying That Data is Being Received on page 24).

23.Verify that all PVCs, including Management PVCs, are configured; and see whether the PVC is active or not (see Checking PVC Connections on page 25).

24.Verify the setup for backup, if applicable (see Verifying the ISDN Line and That Data Can Be Passed Between DBMs on page 26).

The FrameSaver installation is complete.

10