![](/images/new-backgrounds/1142745/14274511x1.webp)
Connecting the COM Port to an Asynchronous Terminal
A
Procedure
1.Configure the
—COM Port in use by your PC is COM1 or COM2.
—COM Port Baud Rate is set to 19.2 Kbps.
—Character length is set to 8 data bits.
—Parity is set to None.
—Stop bit is set to 1.
—Flow Control is set to None.
2.Insert the
COM
or
COM
P O R T
2
C
O
M
COM
3.Insert the other end of the cable into the terminal or PC.
4.Press Enter on the keyboard to display the Main Menu.
If the Main Menu does not appear, recheck the terminal or PC settings (see Step 1), or press the Enter key. Refer to Troubleshooting in the User’s Guide for other possible explanations.
Verifying that Self-Test Passed
To verify that the unit passed its
Main Menu → Status → System and Test Status
The results of the
If any failure messages appear, reset the unit by disconnecting, then reconnecting the power cord. The unit will perform the
6