![](/images/new-backgrounds/1142745/14274527x1.webp)
Automatic Configuration
The FrameSaver unit provides several automatic configuration features. Frame Relay Discovery and configuration is one of these features.
Main Menu → Auto-Configuration
The default discovery mode is 1MPort. In this mode, for each DLCI discovered on the network, the unit creates a network interface DLCI containing two EDLCIs (embedded DLCIs – one for
NOTE:
When
Other modes can be selected. See Setting Up Automatic Configuration in Configuration of the User’s Guide for information about other modes and how the Frame Relay Discovery Mode can be changed.
No automatic configuration occurs until the network cable is connected. If you do not want management links configured or automatic configuration, change the default setting for the Frame Relay Discovery feature.
Time Slot Assignment
Network time slots are discovered automatically when Time Slot Discovery is enabled (the default setting) on the Frame Relay Network 1 Assignments screen. This feature can be disabled if you want to manually configure time slots.
See Assigning Time Slots/Cross Connections in Configuration of the User’s Guide for additional information about this feature.
Setting Up the Modem
The unit has an integral modem for remote management. It is already set up for
Procedure
If using the modem for dialed IP network connectivity (SNMP, Telnet, FTP, or trap
1.Select Modem Port.
Configuration → Management and Communication → Modem Port
2.Minimally, change Port Use to Net Link, and assign the interface’s IP Address and Subnet Mask if it is different from the Node’s. Change Link Protocol to SLIP, if necessary (PPP is the default setting).
3.Save the configuration.
14