ParkerVision 1-CCD manual Connecting to the Camera System, Restraining the Cable Connections

Installation and Startup

Connecting to the Camera System

This section provides connection instructions. Refer to the left-side connection ports.

Restraining the Cable Connections

For the following camera connections:

•Run the cables through the cable restrainer from left to right.

• Tighten the cable restrainer to prevent any cables from dislodging.

This should result in the cables being located approximately in the center of the camera, instead of near the edge.

!To relieve stress on the camera and the cable connections, fasten all cables using the cable restrainer on the back of the camera.

PVI COM	RS-232	S-VI DEO	COMPOSITE	DC
		OUT	VIDEO OUT	POWER
RS-485				POWER

Feed cables from left to right through the restrainer.

Connecting the Video Output

!CameraMan supports both composite and S-VIDEO formats, although you can use only one at a time.

For composite format, connect to the BNC jack on the Connector Box on the back of the camera, labeled COMPOSITE VIDEO OUT, using a standard coaxial cable with a BNC connector (not provided).

!Verify that the Video Select switch is set to

COMPOSITE. The switch is located behind the switch plate on the back right of the camera. Refer to the "Switch Configuration" topic in this section.

For S-VIDEO format, connect to the S-VIDEOjack on the back of the camera using a standard S-VIDEO cable (not provided).

S-VIDEO and

Composite Video

Out Jacks

2-12CameraMan 1-CCD Camera System Installation and Operations Manual