![](/images/new-backgrounds/1318196/31819635x1.webp)
Installation and Startup
System Startup
Once you have made all of the necessary connections and configured the camera to your application, you are ready to turn on the system.
Powering Up
To turn on the system:
1.Switch the Power button on the back of the camera to the ON position. The camera should automatically enter its position- calibration mode and stop at the
2.Verify that the camera is now facing in the direction the FRONT
label was pointing during mounting. Refer to the "Mounting Your CameraMan Camera" topic in this section.
3.If you are using the optional Camera Control Keypad, make sure its address is the same as the address on the camera. Also verify that the camera's pan and tilt functions are working properly.
If the camera does not move, refer to the |
|
|
|
|
|
Troubleshooting section of your Camera Control Keypad |
|
|
|
|
|
or SHOT Director manual. | PVI COM | RS | COMPOSITE | DC | |
| OUT | VIDEO OUT | POWER | ||
| AUX A |
|
|
| |
|
|
|
|
| POWER |
Setting Up Gen Lock
Refer to either of the following manuals for instructions on adjusting gen lock timing parameters:
•CameraMan
•SHOT Director Installation and Operations Manual