General safety advice for electrical power tools / Advice on use
d)When not in use always ensure that electrical power tools are kept out of reach of children. Do not let anyone use the device if he or she is not familiar with it or has not read the instructions and advice. Electrical power tools are danger- ous when they are used by inexperienced people.
e)Look after the device carefully. Check that moving parts are working prop- erly and move freely. Check for any parts that are broken or damaged enough to detrimentally affect the functioning of the device. Have dam- aged parts repaired before you use the device. Many accidents have their origins in poorly maintained electrical power tools.
f)Use the electrical power tool, accesso- ries, inserted tools etc. in accordance with these instructions and advice, and the stipulations drawn up for this particular type of device. In doing this, take into account the working condi- tions and the task in hand. The use of electrical power tools for purposes other than those intended can lead to dangerous situations.
Additional safety advice for paint spray guns
JThe spray gun must never be used for spraying inflammable substances. Spray guns must never be cleaned using inflammable solvents.
JIf you do not know the level of danger a substance presents, do not spray it.
JPrecise observation of the hazard warnings, information and data sheets available from the sprayed medium manufacturer is essential.
JWear a breathing / dust mask! The inhalation of paint mist and sol- vent vapour is hazardous to health.
JWork in adequately ventilated spaces only.
J 
Wear protective glasses!
JNever aim the spray at living creatures.
JDanGEr of explosion! Do not use the device in environments
containing gases, open flames, fires or
J
No smoking!
JPaint and solvents (thinners) must have a flashpoint above 21°C.
QAdvice on use
QDIN-sec / Viscosity
The Parkside paint spray gun PFSP 100 can be used to apply sprayed media with a viscosity up to 80
1.Immerse and fill the supplied measuring cup 12 to the top with the medium to be sprayed.
2.Lift the measuring cup 12 out of the medium to be sprayed and let the liquid flow out (see Figure C).
3.Measure the time in seconds it takes for the flow of liquid out of the measuring cup to cease. This time is the
4.If the value is too high, incrementally add and mix in small quantities of a thinner compatible with the medium to be sprayed. Proceed in ac- cordance with the section about “Preparing the sprayed medium”.
5.Remeasure the DIN-seconds value.
Repeat this procedure until a value is obtained that complies with the values in the table.
QPreparing the sprayed medium
Note: Most paints, varnishes etc. in the shops are intended to be applied by brush not spray. To achieve the best spraying result, you should prepare your paint or varnish etc. in accordance with DIN
GB 9
