3200CL 3400 ZoneA10.09.01.qxp 10/01/2006 17:27 Page 4
INTRODUCTION
The Bluetooth® technology enables voice and data communications via a
Parrot is drawing on its long years of experience in signal processing and voice recognition technology to introduce a
Thank you for buying a Parrot
With its colour interface and customisable wallpaper, the Parrot 3200
KIT CONTENTS
Colour LCD screen
Installation cable
Electronic control unit
Directions for use
Fitting accessories
Microphone
FITTING
First of all, choose the place for the colour screen inside your vehicle. We would advise you to fit it in the centre of the dashboard or near you.
Make sure that you can view the screen at a good angle and that it does not obs- truct your view of the road. Once the
There are two places where you can choose to fit the microphone connection: either directly at the side of the screen or on the cable connected to the bottom of the screen. Place the microphone to the left of the
The installation cable is equipped with ISO connectors and a
Car stereo with line-in jacks:
Preferably use this type of connection by connecting the brown and white wires (or red and black), along with the yellow mute wire to the back of your car ste- reo.
Car stereo with ISO connectors:
Disconnect the car stereo's audio and power leads. Join the female connectors of the kit's cable to the car stereo. Join the vehicle's audio and power supply cables to the male connectors. If the car stereo features a mute jack, connect the yellow wire of the kit's cable to one of the
Car stereo without ISO connectors:
You must purchase an ISO adapter cable.
Fitting the kit's cable:
. The red wire of the kit's cable must be connected to the constant 12V supply, the orange wire to the ignition 12V and the black wire to earth.
. Check the wiring diagram of the car stereo's ISO lead.
On some vehicles, the red and orange wires may need to be reversed. This can easily be done by reversing the two fuse holders.
. Do not connect the orange wire to the constant 12V supply, as you could run down the vehicle's battery.
Checking the installation:
. If your 3200
Otherwise, the ignition 12V and the constant 12V supply have been reversed. In this case, reverse the two fuse holders on the kit's power supply lead.
4