Patton electronic 1082/144 user manual Installation, V.35 connector, Power input connector

4.0 INSTALLATION

Once the Model 1082 has been configured, it is ready to connect to the twisted pair interface, to the serial port, and to the power source. This section tells you how to make these connections.

V.35 connector Line interface

ON

PowerOFF O Interface

Made in the USA

Line

Power input

connector

M d l		.
Power	G		.
	1194E		703/G

Single

DSL

-

Quad

511EMade	in	the
			USA
G.
703/G
.704
	Line

Figure 4. Model 1082 or Model 1082/144 rear view

4.1 CONNECTING THE TWISTED PAIR INTERFACE

The Model 1082 supports communication between two DTE devices at distances to 5 miles (8 km) over 24 AWG (.5mm) twisted pair wire. Two things are essential:

1.These units work in pairs. Both units at the end of the twisted pair DSL span must be set for the same DTE rate.

2.To function properly, the Model 1082 needs one twisted pair of metallic wire. This twisted pair must be unconditioned, dry, metallic wire, between 19 (.9mm) and 26 AWG (.4mm) (the higher number gauges will limit distance). Standard dial-up telephone circuits, or leased circuits that run through signal equalization equipment, or standard, flat modular telephone type cable, are not acceptable.

15