Patton electronic 1092A MAIN MENU Option 2 Display Hardware Configuration, DTE Rate, Clock Mode

MAIN MENU Option 2: Display Hardware Configuration

Select Option 2 to display the configuration of the hardware DIP- switches. To use the Hardware Configuration for the Active Configuration, select MAIN MENU Option 5. Then select “Use Hardware DIP-Switches”. Finally, select MAIN MENU Option 8 to save the changes.

MAIN MENU Option 3: Display Software Configuration

Select Option 3 to display the configuration of the software switches. To use the software configuration for the Active Configuration, select MAIN MENU, Option 5. Then select “Use Software Switches”. Finally, select MAIN MENU Option 8 to save the changes.

SOFTWARE

MAIN MENU Option 4: Setup Software Configuration

Select Option 4 to edit the software configuration of the Model 1092A. To save changes after editing the software configuration, select MAIN MENU Option 5, then select “Use Software Switches” and then select MAIN MENU Option 8.

********************************************************

* SOFTWARE CONFIGURATION MENU - Esc to MAIN MENU		*
*		*
* 1. DTE Rate		*
* 2. Data Format (Async/Sync)		*
* 3. Clock Mode		*
* 4. DSR during Local Line Loop		*
* 5. Response to Remote Digital Loop		*
* 6. DTE controlled Local Line Loop		*
* 7.	DTE controlled Digital Loop	*
* 8.	4-Wire/2-Wire selection	*
*		*

********************************************************

Enter your selection (1-7)>

1. DTE Rate

Select Option 1 in the SOFTWARE CONFIGURATION menu to select the async. or sync. DTE Rate of the Model 1092A. The selections are shown below.

13 14