Patton electronic 1092 user manual S2 Summary Table

Switches S1-4 and S1-5: Asynchronous/Sync Operation

Use Switches S1-4 and S1-5 to configure the Model 1092 for async/sync operation. Both switches must be set in the “Off” position. There is no other valid setting.

S1-4	S1-5	Setting
Off	Off	Async/Sync
On	Off	Reserved
Off	On	Reserved
On	On	Reserved

Switches S1-6 and S1-7: System Clock Mode

Use Switches S1-6 and S1-7 to configure the 1092 for internal, external, or receive recover clock mode.

S1-6	S1-7	Clock Mode	Description
On	On	Internal	System clock
			generated internally
Off	On	External (DTE)	System clock derived
			from terminal interface
On	Off	Receive Recover	System clock derived
			from the received line
Off	Off	Hardware Reset	signal.

Important: A pair of Model 1092s communicate synchronously across the twisted pair line connection. Therefore, you must set these switches whether your application is async or sync. For X.21 or Async applications, please configure one Model 1092 for internal clock mode and the other Model 1092 for receive recover clock mode.

Switch S1-8: Response to RDL Request

Use Switch S1-8 to allow Model 1092 to enter the Remote Digital Loopback diagnostic test when requested to do so by the far end Model 1092 For example, when Switch S1-8 is set to “ON”, it will enter RDL mode (See Section 5.3.2) when requested to do so by the remote Model 1092.

S1-8	Setting
On	Response to RDL Request Enabled
Off	Response to RDL Request Disabled

3.1.2 Configuration Switch Set “S2”

Use the eight DIP Switches in Switch S2 to enable 19.2 kbps synchronous operation, set the loopback modes and the speed of the control port. The following table summarizes default positions of DIP Switch S2. Detailed descriptions of each switch follow the table.

S2 SUMMARY TABLE

Position	Function	Factory Default
S2-1	19.2 kbps Enable	Off
S2-2	Not Assigned	Off
S2-3	Response to LAL from DTE	Off		Disabled
S2-4	Not Assigned	Off
S2-5	Not Assigned	Off
S2-6	Response to RDL from DTE	On		Enabled
S2-7	Control Port Data Rate	On	}	9600 bpsc
S2-8	Control Port Data Rate	On

Switches S2-1: 19.2 kbps Synchronous Rate Enable

Use Switch S2-1 to allow the Model 1092 to operate at the 19.2 kbps synchronous data rate.

S2-1	Activation	Description
Off	Disabled	Synchronous data rate is 32 - 128
		kbps as defined by switches S1-1
		and S1-2
On	Enabled	Model 1092 operates at
		synchronous 19.2 kbps data rate*

*NOTE: To operate at 19.2 kbps, Set Switches S1-1 and S1-2 to the OFF position (see page 6, Switches S1-1 and S1-2).

Switch S2-2: Not Assigned

7 8