Contents
CTS MD-V.35/TCB
3040/V35
Copyright 2000 Patton Electronics Co., All Rights Reserved
An ISO-9001
COPYRIGHT NOTICE
SERVICE
PROPRIETARY NOTICE
PUBLICATION NOTICE
RADIO AND TV INTERFERENCE
EMISSION REQUIREMENTS
CANADIAN EMISSIONS
CHAPTER 2 - SETUP AND INSTALLATION
Contents
CHAPTER 1 - OPERATION
APPENDIX
3040/V35
CHAPTER 1 - OPERATION
Channel Clocking
Fallback Clocking
Channel Selection Modes
Anti-streaming
Channel Tail Circuits
Power Supply
Channel Enable / Disable Switches
Interface Connections
Front Panel LEDs
Power Connection
CHAPTER 2 - SETUP AND INSTALLATION
Factory Configuration Switch Settings
Switch 16 - All to ON
JP4 Thru JP7 Open
JP1 Thru JP3 to Installed
JP8 thru JP12 to Open
Equipment Grounding SW15-1
RTS To CTS Delay SW16-1,2,3
Anti-Streaming SW18-1,2,3
Control Turn-Off Delay in “DATA” Switching Mode SW15-3,4
Receive Data Mode SW18-7
Switch on Data / Control SW17-5,6,7,8
Internal Baud Rates SW15-5,6,7,8
Fallback Mode Selection SW16-6
Fallback Clock Enable SW16-7
Fallback Clocking From Sub-Channel 4 SW16-8
TX Clock Source Selection SW17-1,2,3
NOTE Both TX and RX Clock Source Select MUST Be Set
TX Clock Pin Selection SW17-4
RX Clock Source Selection SW18-4,5,6
J8 thru JP12 Forced DSR/DTR
DCE DCE
FACTORY Test Jumpers JP1, JP2 and JP3
DTR / DSR Forced Active JP8 thru JP12
APPENDIX
Typical Tail Circuit Configuration
V.35
V.35
DB-25 Interface Pins Supported
M-34 Interface Pins Supported
DB-25
Channel Port is a DCE
Channel Port is a DTE
Master Port is a DTE
Switch Control
Master Port is a DCE
Master Port is a DCE
Channel Port is a DCE
Channel Port is a DTE
TECHNICAL SPECIFICATIONS
JP12
V.35 on DB-25
Jumpers
Test
7622 Rickenbacker Drive Gaithersburg, MD
Sales 301 975-1000 Support 301
